What are the main connection methods of quick connectors?
Release Time:
2022-07-15 14:25
The main connection method of quick connector:
A. One-way open and close. When it is not connected, when the ferrule of the parent body is moved to the other side, the beads of the stainless steel quick connector can roll out on their own, and the child body is bounced off by the reaction effect of its spring, and it can turn off the blocking by itself. its flow.
When connected, when the daughter is inserted on the side of the mother where the ferrule is present, it is opened to allow it to flow, the washer is pushed back to the starting position by the effect of the spring, and its beads lock to ensure the connection of the child/parent. , the gasket inside can completely block its leakage.
B. Both ends are open. When it is not connected, when the ferrule of the parent body is pushed to the other side, it will roll out on its own, so the child body is removed; because the child body and the parent body do not exist, they will move towards the outflow.
Connection, when the daughter body is inserted into the mother body, it will be pushed to the original place by the effect of the spring, so that the steel ball will be locked, and it will flow, and the O-ring in it will prevent liquid leakage.
When the quick connector is used for a period of time, it is easy to fail, such as falling off, leakage and other problems. Before using the quick connector, check for leakage. If there is, stop using it immediately and replace it with a new one. At the same time, make sure that the valve of the gas welding torch is closed before connecting. When using, the hose should be firmly inserted into the bottom of the interface and fixed with a hose strap or nut. Avoid using cracked hoses to prevent leaks and shedding. If vibration or impact occurs during use, stop working immediately. If forced to work, the durability of the machine will be reduced.
The quick connector should not be used for purposes other than the connector, such as mixing with metal powder or sand dust, etc., it may cause the situation to fail to work or leak. When using this type of stainless steel joint, it should also be noted that the maximum pressure limit cannot be exceeded, and the fluid used must be a clean fluid filtered by a filter, which does not contain other impurities. When working, the temperature should be controlled within the range of use of the quick connector.
Latest News
More Than 18 Years Focused on Fluid Control Systems
CONTACT US
Address: 403 Building 2, Shiyou Manufacturing Park, No.19 Zhi 'an North Road, Jun 'an Community, Jun 'an Town, Shunde District, Foshan City, Guangdong Province 528329,China
Tel：86-757-2538 8889
Fax：86-757-2538 8816
E-mail：sales@jumedtech.com
E-mail：yan@jumedtech.com
E-mail：phoebe@jumedtech.com
SHARE
Overseas Marketing Center:
Copyright © Foshan JU Medical Component Co., LTD . All Rights Reserved. SEO